Hi all,
Where do you set the feed rate for the Z Axis ?
My generated G code shows it as zero and I have to edit it to show a feed rate.
Ta
Z Axis Feed Rate
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Re: Z Axis Feed Rate
The Z feedrate is labeled as "plunge rate".
The default plunge rate for a tool can be defined in the dialog when adding a tool: When creating a profile toolpath, the plunge rate can be adjusted for that particular profile if desired:
The default plunge rate for a tool can be defined in the dialog when adding a tool: When creating a profile toolpath, the plunge rate can be adjusted for that particular profile if desired:
Re: Z Axis Feed Rate
Thanks Andrew, I am new to this and thought those fields were for setting the feed increment !
Really must read the manual before diving in.
All sorted now
Really must read the manual before diving in.
All sorted now