Hi!
Is there any way to configure the height of tabs? When cutting foamboard that is corrugated on both sides, a tab ending up in a thin section of the board is completely lost!
Thanks
[solved] Tab height
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Indicate the post processor used.
Attach drawing files and screenshots.
Post one question per topic.
Re: Tab height
While creating a tab, you can set its thickness in the options toolbar:
You can also adjust this later for one or multiple selected tabs in the property editor.Re: Tab height
I had completely missed that! Thank you!