Andrew,
I installed .8 beside .6 so I can still work with the prior installed version.
I have 'Always show all properties' set for the Property Editor.
In version .8 I am confronted with more 'Show' buttons.
e.g.:
- the 'Total Area' for a single circle.
- or the 'Total Length' & 'Area' & 'Total Area' for a single polyline.
- ...
It doesn't matter if I turn on 'Always show all properties' or not.
Figuring that this preferences has no influence on showOnRequest that was changed for single (slow) Hatched area.
Figuring that a single entity selection does not turn on/off summed 'Total' properties.
How can I avoid 'Show' buttons in later versions than 3.27.6.0?
Regards,
CVH
Show buttons in version 3.27.8.0
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
-
CVH
- Premier Member
- Posts: 4955
- Joined: Wed Sep 27, 2017 4:17 pm
-
CVH
- Premier Member
- Posts: 4955
- Joined: Wed Sep 27, 2017 4:17 pm
>>