I know this can be done in several steps but was seeing if i can do it in one
I want to draw a line from a specific point at a constrained angle till it intersects another line. When I use the "on entity" snap it does not work. I know i can use the trim command to do this but i have to do this many many times and would be nice if i could do all at once when i create the line
Thanks
draw line at a fixed angle that intersects another line
Moderator: andrew
Forum rules
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Always indicate your operating system and QCAD version.
Attach drawing files and screenshots.
Post one question per topic.
Re: draw line at a fixed angle that intersects another line
Do you know the exact distance? If yes then it's doable in one step.aland wrote:...till it intersects another line.
If not ... a two step solution is the best what I can think of ...
Work smart, not hard: QCad Pro
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Win10/64, QcadPro, QcadCam version: Current.
If a thread is considered as "solved" please change the title of the first post to "[solved] Title..."
Re: draw line at a fixed angle that intersects another line
No I don't knpw the exact distance.