I just joined the group and just began using QCad. I've used other CAD/CAE S/W in the past as a part of my job, such as Bentley Microstation and various products offered by Intergraph Corporation back in the 1980s and 1990s. I've already been able to make a pretty good start in QCad 2.0.5 Community Edition on Linux, once I was able to figure out how things work with the command line. So far, I'm pretty impressed wit the product.
I look forward to the fellowship of the forum.
Post to this forum to introduce yourself to this forum if you are new here. You might want to include some information about the work you are doing or planning to do with QCAD.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests