FS#1020Line2PEx, Option-bar for angles disregard the Decimal Point settings
- Type
- Bug
- Status
- Closed
- Resolution
- Won't fix
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.4.6
- Operating system
- Windows XP
- Reported
- 2014-02-11 by Husky
- Closed
- 2015-01-21 by andrew
My QCAD setting for "Decimal Points" is "dot" instead of "comma".
(Application Preferences, General, Coordinate Format, Decimal Point: Dot '.'(Default))
The new Line2PEx tool will only accept a comma - if I use a dot it will be automatically replaced by a comma.
The displayed angle in the drawing will use a dot.
No red Text font warning for using an invalid value.
I used a screen-shot with an additional coordinate option to make it a bit clearer:
Closure comment
features have been ported to the standard line tool
Comments (2)
After testing I find i have the opposite problem.
On my system at work (windows vista) I can only use 'Dot', which for me is fine - but changing to Comma doesn't work if I needed to!
I think the spin box should probably be changed into a RMathLineEdit instead. This would also allow for formulas to be entered.
I've also posted this to the forum for riverbuoy:
http://qcad.org/rsforum/viewtopic.php?f=107&t=2760&p=9515#p9515