FS#1260"Break out segment" again arc is not a sharp cut to the arc ...
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.10.0
- Operating system
- All
- Reported
- 2015-09-06 by Husky
- Closed
- 2015-09-08 by andrew
Break out segment / Auto trim again arc is not a sharp cut to the arc (to long or to short),
Break out manual can't snap to a line/arc intersection,
Closure comment
Display preferences issue.
Comments (3)
Thanks. Can you please attach the DXF file?
I'm not anymore sure if this is a bug or just a question of my personal display arc settings ...
I changed the "Application Preference" settings for "Appearance" / "Minimum angle step for rendering arcs (degrees)" from the default 0,2 to 0 and now it looks good. Before I did that I was only able to snap to the end of the line (which was to short or to long displayed). I assume it was mathematically correct but if I see where I can snap the line I get the feeling it isn't correct ...
What do you think?
Yes, looks like a display accuracy problem.
It probably looked like that, but display preferences have no influence on the actual geometry of entities or snapping.