FS#1363New Tool - make lines horizontal or vertical
- Type
- Feature Request
- Status
- Assigned
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.12.5
- Operating system
- All
- Reported
- 2016-01-28 by anonymous
New Tool Request:
To have a tool to make any given line which is 'not' orthogonal already into an orthogonal line.
For example if I had a line at 30 degrees by using the tool I could change the line to be either horizontal or vertical.
Comments (1)
Simply a question of setting the line angle to 0-90-180-270 degrees.
Or that of a selection of line segments.
IMHO such tools are only used by a few and may saturate the GUI with unused features.
I would decline this request.
Regards,
CVH