FS#1403Copy and Paste vectorpoint to built a spline in QCAD
- Type
- Feature Request
- Status
- Closed
- Resolution
- Implemented
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.13.1
- Operating system
- All
- Reported
- 2016-03-21 by tkmbi
- Closed
- 2016-09-15 by andrew
Would it be possible like in AutoCAD and Draftsight, to copy (from CSV or TXT) into the command line of qcad a table with
vectorpoint to built up a Spline in QCAD ?
Sample:
Spline
10.5,10(LR+CR)
20.8,20.4(LR+CR)
and so on
this text would than paste into the command line, and works like a macro.
Will be very helpful to generate a Spline where the vectorpoint had been calculated with for example "Excel"
Comments (3)
Hi, thats great, I'll try it out, perfect.
I tried, but no success, is this impemented i 3.15 ?, I just downloaded
Thomas: "implemented" in this tracker means that the feature has now been built into QCAD and will likely be available in the next release (if it passes tests, etc). See also change log at:
http://www.qcad.org/en/changelog