FS#1565Disappearing blocks.
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.16.7
- Operating system
- OpenSUSE Linux
- Reported
- 2017-03-28 by teegee
- Closed
- 2017-03-28 by andrew
Blocks disappear (or their content does) after creating again with the same name. In attached file:
1) Created cirle
2) Select circle, BC, select center, name is 'testblock'
3) Repeat 2) -- circle is now gone
Comments (1)
Thanks for your report.
You are creating a recursive block (a block that contains a block reference, referencing the same block).
Recursive blocks cannot be displayed since that would take an infinite amount of time and memory.
I will close this report. If you still have a question about blocks, please post to the forum at:
https://www.qcad.org/rsforum/viewforum.php?f=32