FS#16463.18 has a HATCH issue
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD/CAM
- Severity
- Medium
- Priority
- Low
- Reported version
- 3.18.1
- Operating system
- Windows 7
- Reported
- 2017-10-25 by Thomas
- Closed
- 2017-10-25 by andrew
If you pres the "hatch icon" then the word "hatch" appears in the command window, but. . . nothing happens.
But if you type "hatch" followed by "enter" then finally the Hatch Window pops up.
Closure comment
Please re-open if a new installation does not solve the problem.
Comments (1)
I cannot reproduce this here. Please wipe your installation and re install again into a new, empty directory. There might be a mixed installation of an older (<=3.15.x) and a newer version on top of each other. This can happen if the older version was installed from ZIP or EXE and the newer from an MSI.