FS#1816TAB function in CAM module fails
- Type
- Bug
- Status
- Closed
- Resolution
- Won't fix
- Category
- QCAD/CAM
- Severity
- Low
- Priority
- Low
- Reported version
- 3.21.3
- Operating system
- All
- Reported
- 2018-11-07 by Arno
- Closed
- 2018-11-20 by andrew
When using (adding a TAB on a radius fails).
Example:
When length of the TAB is set to 1 mm.
After export to *.nc code the code is not ok.
And then check this is NC viewer or gcode sender the length is not set to 1 mm but is smaller.
On a line this function (TAB) is correct working.
Closure comment
No further information received, no file provided. Please re-open and attach file if problem persists.
Comments (1)
Please attach your drawing file (DXF), thanks.