FS#1918Splines whit control points of order 1 and 4 not selected with partially selecting cursor R>L draw
- Type
- Bug
- Status
- Closed
- Resolution
- Fixed
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.22.1
- Operating system
- Windows 7
- Reported
- 2019-07-06 by CVH
- Closed
- 2019-07-06 by andrew
Set up a spline with control points let's say of the order 3.
Clone it 3 times with some offset in x&y.
Edit the degree property and set 1ste to 1, 2nd to 2, aso
Draw select partially from right to left.
Those of the order 1 and 4 aren't selected.
Regards
Closure comment
Fixed for degree 1, out of scope for degree 4 and higher (won't fix / implement)
Comments (1)
Thanks. Degree 1 splines (polylines) will be implemented / fixed for the next release.
For degree 4 and higher, unfortunately, I'm going to have to close this as "out of scope". I'm unaware of any algorithms to deal with intersections of splines of degree 4 and higher. Splines of degree 4 and higher are mostly of academic interest and mainly supported in QCAD for compatibility reasons.