FS#1969font name not saving correctly
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.23.0
- Operating system
- All
- Reported
- 2019-10-12 by ljbuller
- Closed
- 2019-10-17 by andrew
0
STYLE
5
31D
330
239
100
AcDbSymbolTableRecord
100
AcDbTextStyleTableRecord
2
textstyle11
70
0
40
0.0
41
1.0
50
0.0
71
0
42
0.2
3
CASTELAR.TTF
4
1001
ACAD
1000
Castellar
1071
0
Closure comment
Please request a re-open if you still think this is a bug. Please provide further information in this case, thanks.
Comments (5)
the font is Castellar.ttf the 3 group code leaves out one L making it castelar.ttf
the 1000 groupcode has the spelling correct as Castellar
Could it be that the font file name (on disk) is "CASTELAR.TTF"?
I'm thinking about the 8.3 file name limitation also.
I have confirmed that Castellar.ttf is the correct name. If the name contained in the 1000 groupcode is consistent, then I can use that instead of the 3 groupcode name. Could you confirm that is how QCAD works?
What is the logic to remove a letter in the middle of a name? I did not see any restriction to 8.3 in the Autodesk 2012 dxf reference.
This is all handled by the OpenDesign Teigha libraries, not QCAD. I don't know what the logic is behind the .ttf file name saved to DXF. I would have expected that to match the file name on disk.
Larry, Andrew,
Please refer to:
https://learn.microsoft.com/en-us/typography/font-list/castellar
Castelar.ttf is the font file.
Castellar is the font family.
Regards
CVH