FS#2033Repeated warning message while updating toolpath
- Type
- Bug
- Status
- Closed
- Resolution
- Fixed
- Category
- QCAD/CAM
- Severity
- Low
- Priority
- Low
- Reported version
- 3.24.2
- Operating system
- Linux (All / Other)
- Reported
- 2020-01-25 by jbauman
- Closed
- 2020-08-31 by andrew
While updating or regenerating toolpath on the attached dxf file I repeatedly get the warning message in the attached jpg file. If I keep clicking OK then the toolpath is successfully generated. This did not happen in version 3.23.0 with the same file.
- DM4.dxf2.8 MB
qcadcam1.jpg14 KB- QCAD3.conf89 KB
Comments (1)
Workaround: Please make sure that Edit > Application Preferences > Widgets > Command Line > Show warnings as dialogs is switched off.