FS#2235Invalid symbol table name
- Type
- Bug
- Status
- Closed
- Resolution
- Fixed
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.26.2
- Operating system
- Windows 10
- Reported
- 2021-04-27 by tomaz
- Closed
- 2021-06-24 by andrew
Hello,
I have got a dwg file from architect, which I can open, but I get "Invalid symbol table name" when I try to save it. I do not know which software was used to create it.
I have tried to change all spaces and national characteds in block and layers names as advised elswhere, but that didn't help.
Lp
Tomaž
Closure comment
This has likely been fixed in QCAD 3.26.4, please re-open otherwise.
Comments (2)
The cuprits seem to be two blocks with the names
Hina delavnica_05_4
and
Hodnik_ stopniče_01_6
Note that "š" type character "" which is invisible in QCAD and might be shown as a square in your browser or as a faint "š". You can either remove that or replace it by a normal "š" or "s".
Indeed, after renaming those two I can save my changes!
I missed them because they were "invisible" in block editor.