FS#2331Tabs: Control over on which particular profile used.
- Type
- Feature Request
- Status
- Assigned
- Category
- QCAD/CAM
- Severity
- Low
- Priority
- Low
- Reported version
- 3.27.1
- Operating system
- All
- Reported
- 2022-01-15 by Husky
Currently if I position one Tab (KT) to stacked profiles QCADCAM will use it on ALL in Z matching profiles. Practically in most cases would be to use tabs only on the lowest profile.
It would be nice to have some kind of control on which profile a tab has to be used.
Husky-2022.01.15-05.png114 KB
Comments (1)
e.g. a profile property 'use tabs'.
Or a TAB in 3D
Regards,
CVH