FS#2406File > SVG Export: wrong arcs in blocks with negative scale factors
- Type
- Bug
- Status
- Closed
- Resolution
- Fixed
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.29.6
- Operating system
- All
- Reported
- 2022-10-07 by Terry
- Closed
- 2024-04-16 by andrew
- Votes
- 1
- Duplicates
- FS#2435
When using SVG export on a drawing with a block defined, the export is incorrect. Arcs are drawn incorrectly and parts of the block are missing. If that block is exploded, the SVG export is correct. Attached is a block on the lower left and the same block on the lower right after explode. Also attached is the resulting SVG file.
This is not always the case. Some blocks are correctly exported to SVG. The upper row is again a block on the left and the same block exploded on the right. It exports properly.
Comments (1)
Hi,
Seems to be a Block scale issue.
The lower Block is mirrored in Y with scale= -1
The upper Block is inserted at unit scale.
Regards,
CVH