FS#345unit foot: no dotted line
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Very Low
- Reported version
- 3 Beta 3
- Operating system
- All
- Reported
- 2011-10-28 by anonymous
- Closed
- 2011-10-30 by andrew
can't make a dotted line on a drawing with unit foot.
- drawing unit: foot (length taken from a actual architecture plan)
- layer settings: as shown in the screen shot
- selected line is on layer "dotted"
- line types is shown as continues for almost everything
dot_foot.png122 KB- floor plan.dwg16 KB
Comments (1)
This has to be adjusted with the line type scaling factor if required.