FS#435QCAD3 RC3 Windows XP - Stretch command does not appear to function
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD (main)
- Severity
- Medium
- Priority
- Low
- Reported version
- 3 RC3
- Operating system
- All
- Reported
- 2011-12-14 by qcaduser2004
- Closed
- 2011-12-14 by andrew
The modify tools -> stretch command does not appear to function.
The two attachments contain the source drawing (blackburne_engine_breather_0210A.dxf) and five screen shots (qcad3_rc3_stretch.odt) showing the steps taken to replicate the problem.
I have also performed a similar exercise with a Linux trial version 3.0 RC2 (OpenSuse 11.4) with the same result.
Regards
Closure comment
Improvement: r20017
Comments (3)
Can you please try to 'draw' the stretch area well over the edge of the part you want to stretch as shown in the user manual at:
http://www.ribbonsoft.com/qcad/manual_reference/chapter28.html#10
Stretching means moving all end points inside the given rectangular area. If the area is drawn with a zero height or width, nothing will be stretched.
Next release will allow for zero-width / zero-height box and support the way you tried to stretch.
Thank you for the clarification. I was following what I did in v2.2.2.0. Not realising that I was missing a trick.
I have now been able to stretch the entity. Thank you for including this anomaly in the next release. Regards.