When opening a DXF created by 2.2.2 the block entities are sometimes not being drawn in correct position and orientation.

The following is seen on the console (Which I think is related)

Debug: importing entities in block ' "Sw1pwo" '
Warning: RDwgBlockReferenceImporter::import: block reference references invalid block: "*X15"

and also (which is probably not related)
Debug: importing entities in block ' "A$C6329746C" '
Warning: RSpline::updateFromControlPoints: not enough control points: 0
Warning: RSpline::getExploded: invalid spline
Debug: RSpline: knotVector ignored
Debug: RSpline: knots: 11
Debug: RSpline: order: 4
Debug: RSpline: controlPoints: 7
Warning: RSpline::updateFromControlPoints: not enough control points: 0
Warning: RSpline::getExploded: invalid spline
Debug: RSpline: knotVector ignored
Debug: RSpline: knots: 11
Debug: RSpline: order: 4
Debug: RSpline: controlPoints: 7

Drawing file shown.

This could be a bug in 2.2.2, but it would be nice to ensure 3 can pull in old drawings without us having to rework them all.

Any questions james at enrogen dot com.

James