FS#468hatch not existing after save+reopen
- Type
- Bug
- Status
- Closed
- Resolution
- Fixed
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3 RC3
- Operating system
- Ubuntu Linux
- Reported
- 2012-01-18 by stefan
- Closed
- 2012-01-18 by andrew
After several hints (see IDs 464 and 465) I removed all non-zero Z-coordinates inside a dxf, so hatches seem to work even with pattern now. But after save and re-open, the hatch is not existing anymore (even with select all).
Comments (3)
attached: screen recording
I can reproduce that bug in QCAD 3 RC2/3 but not in the current development version.
bug is closed already, but perhaps this clarifies though: saving file with QCad3 and opening with QCad2 shows the correct hatch