FS#476Stretching dimension
- Type
- Bug
- Status
- Closed
- Resolution
- Not a bug
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3 RC3
- Operating system
- All
- Reported
- 2012-01-28 by hungerburg
- Closed
- 2012-02-06 by andrew
Draw a horizontal dimension. Stretch (S S) it. The label remains in place. It should instead go to the new center. (Unless it was manually positioned perhaps...)
Workaround: Pick one extension and drop it to where it was, label gets centered.
Comments (2)
Not reproducible with QCAD 3 RC3, Windows 7.
Could this only be the case for drawings imported from QCAD 2?
I now realise, that this only happens with one single drawing. Maybe I have done something stupid. Please close.