FS#873command line does not accept distance value for funtion "parallel lines"
- Type
- Feature Request
- Status
- Assigned
- Category
- QCAD (main)
- Severity
- Low
- Priority
- Low
- Reported version
- 3.2.0
- Operating system
- Ubuntu Linux
- Reported
- 2013-08-08 by d.tischler
In the comnmand line, I can sucessfully enter for example the radius of a circle to draw (Space 100 Enter) but the command line does not accept a value for the distance when drawing parallel lines (l p space 100 enter -> error).
Comments (1)
The first is no longer feasible because both use the Option Toolbar.
I would move to closure.
Regards,
CVH