FS#2267 : In-place block editing: some block references not faded

Status Closed
Percent Complete
100%
Task Type Bug Report
Category QCAD (main)

Assigned To

Operating System All
Severity Low
Priority Very Low
Reported Version 3.26.4
Due in Version Undecided
Due Date Undecided
Votes
Private

Attached to Project: QCAD Bugtracker
Opened by Zilmo - 13.08.2021
Last edited by Andrew - 16.08.2021

FS#2267 - In-place block editing: some block references not faded

I noticed a bug while editing blocks in place. When I opt to edit in place, most of the surrounding blocks fade out properly, but some don’t. Although I can’t edit them, as they are not faded, It can be tricky to identify what is in the current block or not while editing a bigger assembly.

Another suggestion is to add a keyboard shortcut command to the “save and close”.

Otherwise, this is a fantastic feature that really enabled me to buy the QCAD and start using it professionally. In place editings are a key feature for my projects and drawings.

Thanks in advance.

IMG 1 shows my drawing

IMG 2 shows a block being edited “not in place”

IMG 3 shows a surrouding block being edited “not it place”

IMG 4 and 5 shows the in place edit of the block shown in IMG 2 and the surrouding blocks not being properly faded.