QCAD Bugtracker

  • Status Assigned
  • Percent Complete
  • Task Type Feature Request
  • Category QCAD/CAM
  • Assigned To
  • Operating System All
  • Severity Low
  • Priority Very Low
  • Reported Version 3.27.1
  • Due in Version Undecided
  • Due Date Undecided
  • Votes
  • Private
Attached to Project: QCAD Bugtracker
Opened by Husky - 15.01.2022

FS#2331 - Tabs: Control over on which particular profile used.

Currently if I position one Tab (KT) to stacked profiles QCADCAM will use it on ALL in Z matching profiles. Practically in most cases would be to use tabs only on the lowest profile.

It would be nice to have some kind of control on which profile a tab has to be used.

CVH commented on 16.01.2022 05:23

e.g. a profile property 'use tabs'.
Or a TAB in 3D



Available keyboard shortcuts


Task Details

Task Editing