- Status Closed
- Percent Complete
- Task Type Bug Report
- Category QCAD (main)
-
Assigned To
Andrew - Operating System All
- Severity Low
- Priority Very Low
- Reported Version 3.32.2
- Due in Version Undecided
-
Due Date
Undecided
-
Votes
2
- Pete Vickerstaff (01.03.2025)
- CVH (01.03.2025)
- Private
Attached to Project: QCAD Bugtracker
Opened by John Hyslop - 01.03.2025
Last edited by Andrew - 11.03.2025
Opened by John Hyslop - 01.03.2025
Last edited by Andrew - 11.03.2025
FS#2648 - Modify > Break out Segment: incomplete or duplicates for circles, ellipses, polylines
- Modify > Break out Segment
- activate Line Selection Mode
- draw line through circle, ellipse, closed polyline or open polyline, so that the line intersects the entity more than once
This can result in duplicate entities or incomplete trimming
In short:
D2 in line selection mode is handled by a Pro Addon script BreakOutPro.js.
It calls the standard script BreakOut.js for each crossed entity ...
... And then again for each intersection with the auxiliary line.
Creating a fully new trimmed copy each time. Deleting the original.
For closed shapes resulting in duplicates.
For open shapes with more intersections the outcome varies.
Not all are duplicates, some are partial duplicates.
Per definition not always including the intended results.
Also:
Please close FS#1983 D2 in line mode is kinda a solution I use these days.
One of the many trailing open reports.
Regards,
CVH