Center, Point, Angles
Dette indhold er ikke tilgængeligt i dit sprog endnu.
Toolbar / Icon:
Menu:
Draw > Arc > Center, Point, Angles
Shortcut:
A, R
Commands:
arcc | ar
Description
Section titled “Description”Draws an arc from its center point, a point on the arc line, start angle and end angle.
- Choose the direction of the arc in the options toolbar.
- Set the center of the arc using the mouse or enter a coordinate in the command line.
- Define the radius by clicking a point on the arc or by entering a coordinate into the command line. You may also enter the radius in the command line.
- Set the start angle with the mouse or by entering a coordinate or the angle in the command line.
- Set the end angle the same way as the start angle.