Center, Point, Angles

Det här innehållet är inte tillgängligt på ditt språk än.

Toolbar / Icon:

Menu:

Draw > Arc > Center, Point, Angles

Shortcut:

A, R

Commands:

arcc | ar

Draws an arc from its center point, a point on the arc line, start angle and end angle.

Choose the direction of the arc in the options toolbar.
Set the center of the arc using the mouse or enter a coordinate in the command line.
Define the radius by clicking a point on the arc or by entering a coordinate into the command line. You may also enter the radius in the command line.
Set the start angle with the mouse or by entering a coordinate or the angle in the command line.
Set the end angle the same way as the start angle.